Filter
Top Products
148 ICX (International) issued October 2000 ICX-50-700
Chapter 5. Key Telephone Features Section 700 - Operation
To store the Call Log number in a personal speed dial:
Hardware Requirements
• Caller ID daughter circuit card on the Loop Start Trunk Card if a Loop Start Trunk receives the
call.
• ISDN (PRI-T Point) if ISDN card receives the call.
• Large Display Telephone or 44-Series Small Display Telephone.
Considerations
• Caller ID is available ISDN PRI.
• Caller ID circuit card must be installed and enabled. (See “Caller ID” on page 29).
3. Press the following keys to view the call log:
# - Move forward in call log
* - Move back in call log
NEXT - View the next 5 calls
PREV - View the previous 5 calls
4. To return a call, (and exit the Call Log)
Press the Soft key to the left of the desired number to
access Access MCO 1 (dial 9 [UK/HK] or 0 [Taiwan,
Malaysia, Indonesia]), dial add digits if required (in USA
only, usually “1” ), and dial the displayed caller ID #.
OR...
Press the Soft key to the right of the desired number to
access MCO 1 (dial 9 [UK/HK] or 0 [Taiwan, Malaysia,
Indonesia]), and dial the caller ID #.
Action Result
1. Go off-hook or press the ON/OFF key. Intercom dial tone
2. Enter the Call Log feature code (default = CONF 96). Phone enters call log mode.
3. Press the following keys to view the call log:
# - Move forward in call log
* - Move back in call log
NEXT - View the next 5 calls
PREV - View the previous 5 calls
4. To store the call log number in a personal speed dial:
Press the PROG key, the speed dial bin number (80-99)
and press the left Soft key (to dial the add digits, usually an
area code) and press the HOLD key.
OR...
Press the PROG key, the speed dial bin number (80-99)
and press the right Soft key and press the HOLD key.
Action Result