Filter
Top Products
134 ICX (International) issued October 2000 ICX-50-700
Chapter 5. Key Telephone Features Section 700 - Operation
To retrieve a held call on a specific trunk:
Hardware Requirements
•N/A
Considerations
•N/A
Floating Hold
Floating Hold is a type of System Hold that allows you to retrieve a held call from any extension that
has an FF key assigned to the same Floating Hold orbit where the call is held. You can also retrieve a
call by dialling the Floating Hold orbit number for the held call.
Floating Hold is useful when the intended recipient of a call must be located via a page. The call can
be placed in a Floating Hold “orbit” and that orbit number announced during the page. The paged
party can then pick up the call by dialling the orbit number or by pressing an FF key assigned to that
orbit number.
Note: To place a call on Floating Hold, you should have at least one FF key assigned to a Floating
Hold orbit number (001-576).
Operation
To place a call on Floating Hold:
To retrieve a call from Floating Hold:
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Specified Trunk Answer code (default = *0). Enter TRK # displays
3. Enter the trunk number.
Action Result
1. While on a call, press the Floating FF key (system program-
ming required) or press the HOLD key.
• Intercom dial tone
• Hold CO XXX displays (where XXX
= outside line number)
Action Result
1. (A) Press the FF key assigned to the Floating Hold orbit
number where the call is held.
OR...
(A) Enter the Floating Hold Answer feature access code
(default = *9).
(B) Enter the Floating Hold orbit number (001-576) CPC-
288/576), 01-96 (CPC-96) or 001-099 (CPC-288/576) or
01-09 (CPC-96) (See considerations below.)
CO XXX displays if line released (where
XXX = outside line number)