Filter
Top Products
Section 700 - Operation Chapter 5. Key Telephone Features
ICX-50-700 ICX (International) issued October 2000 171
Note: If Headset mode is already on, the following procedure turns it off. If Headset mode is off,
this procedure turns it on.
Hardware Requirements
• A headset must be installed.
Considerations
• Intercom Dial Tone is enabled/disabled regardless of Headset mode (per programming for the
Extension Class of Service [COS])
Hot Dial Pad
Description
The dial pad on digital key phones can be designated as “hot” on an extension-by-extension basis.
The Hot Dial Pad allows the user to initiate a call without going offhook. Extensions with the Hot
Dial Pad enabled can initiate calls by pressing any of the numeric keys (0-9). The “*” and “#” keys
are not hot.
The Dial Pad can be hot under these conditions:
• When the extension is idle
• When the extension is holding a call
• When the extension is receiving a page.
The Dial Pad cannot be hot under these conditions:
• When a call is ringing at the extension (intercom or trunk)
• When the extension is on a call.
Hardware Requirements
•N/A
Considerations
Paging: The Hot Dial Pad cannot be used to initiate a page.
Action Result
1. Pick up the handset or press the ON/OFF key. Intercom dial tone
2. Press the PROG key.
3. Enter 90 for Headset mode.
4. Replace the handset or press the ON/OFF key.