Filter
Top Products
272 ICX (International) issued June 2000 ICX-50-700
Chapter 7. SLT Features Section 700 - Operation
To cancel an Absence Message
Hardware Requirements
•N/A
Related Programming
• FF1 (System): Extension Class of Service Setting
• FF3 (Extension): Extension Class of Service Assignment
• FF8 (Maintenance): Absence Messages
Considerations
• Calling parties without a display get a busy signal, rather than the Absence Message.
• Regardless of setting an Absence Message on a DDI/DIL extension, DDI/DIL calls are routed
according to the trunk ringing setting.
• An absence message may also be cancelled by dialling 7**. This cancels Do-Not-Disturb (DND)
and Call Forwarding-All Calls as well.
Account Codes
Description
You can assign account codes to clients to facilitate billing and to track call dates and times, numbers
called, and outside line numbers used. This information is printed for each account on the Call
Logging record.
In addition verified account codes may be used to change the Toll Restriction Service (TRS) (Call
Barring) level to allow calls to numbers otherwise restricted.
Account codes may be either forced or unforced (voluntary) and either verified or unverified.
This feature works with Call Logging. Before making an outgoing call, a station user can silently
enter an accounting or client billing code. Then later, the Call Logging reports will show the Code
dialled for each call, and even sort the report by these Codes.
There are two different types of account codes: Non-Verified and Verified Account Codes. Prior to
Version 5.0, the maximum amount of account code numbers for both types could range from 1-10
digits. Beginning with Version 5.0, a second mode has been added that allows the user to set the
maximum amount of account code numbers from 1-4 digits. An account code error will occur when
more than the maximum number of digits are entered.
Action Result
1. Lift the handset. Intercom dial tone
2. Enter the Absence Message code (default = 729 [UK/HK]
or 729# [Taiwan, Malaysia, Indonesia]).
3. Flash the hookswitch.
4. Replace the handset.