Filter
Top Products
302 ICX (International) issued June 2000 ICX-50-700
Chapter 7. SLT Features Section 700 - Operation
Hardware Requirements
• External relays, amplifier, and speakers are required for external paging.
Related Programming
• FF1-0-02: Paging Override
• FF1-0-03: Extension COS (Paging)
• FF1-0-04: Trunk COS (Paging)
• FF1-2: Dial Plan
• FF2: Trunk COS
• FF3: Extension COS
Considerations
• If an external paging system has been connected, pages can be made to Paging groups 0-9
through the external speakers. Voice paging can also be heard over the extensions in groups 0-9.
• An extension can belong to more than one paging group.
• Only one page may be performed at a time. If you attempt to make a page while another
extension is paging, you will receive a busy signal unless your system allows Paging Override.
• Beginning with Version 4.5 and higher, the paging system can be set to “timeout” if a page
remains unanswered for a specified length of time (0 to 255 seconds). If this feature is set and the
timeout period has elapsed, the page originator’s handset will emit a Fast Busy Tone.
Room Monitoring
Version 4.0 and higher
Description
This feature allows the user to monitor the sounds in a room from another extension or room. The
transmitter in the telephone handset is used as a remote “microphone” for monitoring these sounds.
To activate this feature, the monitored extension must enable the Room Monitor feature before the
monitoring extension can listen to the sounds in the room. The monitored extension can be enabled
using an SLT, DSLT, or Key Telephone. No special programming is required to allow an extension to
enable the monitored mode.
Operation
To set up the monitored extension:
Action Result
1. Dial the monitored extension access code (default 775)
Note: The handset must be off-hook to activate the
Room Monitor feature.
You will hear a confirmation tone after
the monitored extension has enabled the
Room Monitor feature.