Filter
Top Products
Section 700 - Operation Chapter 6. DSLT Features
ICX-50-700 ICX (International) issued June 2000 253
This feature allows the user to monitor the sounds in a room from another extension or room. The
transmitter in the telephone handset is used as a remote “microphone” for monitoring these sounds.
To activate this feature, the monitored extension must enable the Room Monitor feature before the
monitoring extension can listen to the sounds in the room. The monitored extension can be enabled
using a SLT, DSLT, or Key Telephone. No special programming is required to allow an extension to
enable the monitored mode.
Operation
To set up the monitored extension:
Additional operations may be performed from the monitored extension when it is in monitored mode:
Note: When a monitored extension receives a call, the caller hears a busy tone.
To set up the monitoring extension:
The monitoring operation can be allowed or denied by extension COS and is controlled by the Busy
Override feature. If Busy Override is denied and the user attempts to monitor an extension, the user
will hear a fast busy tone.
Action Result
1. Dial the monitored extension access code (default 775),
OR...
Note: The handset must be off-hook to activate the
Room Monitor feature.
You will hear a confirmation tone after
the monitored extension has enabled the
Room Monitor feature. (If the monitored
extension has an LCD display, a confir-
mation message will also be shown.)
Press an FF key assigned with the monitored access code
Action Result
1. Placing the handset back on-hook or pressing ON/OFF Monitored mode is cancelled. Extension
returns to idle.
2. Pressing digits 0-9, *, #, PROG, CONF, MIC, MENU,
PREV, NEXT, REDIAL, MEMORY, FF Key
No response is given. Extension remains
in monitored mode.
3. FL/R Monitored mode is cancelled. Dial tone is
returned to handset.
Action Result
1. Dial the monitoring extension access code (default 776)
and
the extension number of the monitored extension, OR...
The monitoring extension enters the mon-
itoring mode. (If the monitored extension
has an LCD display, a confirmation mes-
sage will also be shown.)
Press an FF key assigned the monitored access code and
the
extension number of the monitored extension, OR...
While the handset is on-hook, press an FF key assigned to
the Room Monitor followed by the monitored extension
number.
The monitoring extension will automati-
cally enter the monitoring mode.