Filter
Top Products
Section 700 - Operation Chapter 7. SLT Features
ICX-50-700 ICX (International) issued June 2000 293
• FF3: Extension COS
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See “To camp a call onto a
busy extension:” on page 266.
Conference Calls
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time.
Note: The SLT does not support 8 party conference calling.
Any combination of extensions and trunk lines can be in the conference as long as the original
extension is in the conference and the total number of parties does not exceed 3. Only one operation is
used to establish and add to a conference. You simply have to place the current call on hold, dial the
next party and press the CONF key. No different operation or access code is required to add
additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party
conference calls:
•3 extensions
• 2 extensions and 1trunk
• 1 extension and 2 trunks
Operation
To establish a conference call:
Hardware Requirements
•N/A
Related Programming
• FF3: Extension COS
Action Result
1. While on a call, hookflash to place your current call on hold.
2. If adding an outside party, dial a trunk access code (default
= 9 [UK/HK], 0 [Taiwan, Malaysia, Indonesia], or 81-84).
• Outside dial tone
3. Dial the number of the party you wish to add to the call.
4. Hookflash when your call is answered.
5. To add additional parties, repeat steps 1-4
6. To drop out of the conference call, hang up.