Filter
Top Products
86 ICX (International) issued October 2000 ICX-50-700
Chapter 4. User Maintenance Section 700 - Operation
Some bushiness may have special operating hours based on the day of the month. For instance, a
company may work half-days on the second Saturday of each month.
Operation
To set the Day of Week Modes:
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 79.)
81-
User MAINT displays
2. At the 81 level, enter 07.
3. Press the HOLD key. 8107-
System Mode displays
4. Enter 3.
5. Press the HOLD key. 3-
D of Week PTN displays
6. Press the HOLD key. 300 :
1st SUN Pattern displays
7. Enter pattern (0 - no pattern, 1 - pattern 1, 2 - pattern 2, 3 -
pattern 3) for the first Sunday.
Note: To clear an entry or existing data, press the
FL/R
key.
8. Press the HOLD key to store the entry. Next Day of Week mode displays
9. To set additional Day of Week modes, press the volume up
or down key or press the HOLD key to move to the desired
mode.
Desired Day of Week mode displays
10. Repeat steps 7-9 until the remaining days in the month are
set.
Note: The entry positions are listed in Table 10 on page 87.
11. Press the
MEMORY key to exit the entry mode. 3-
D of Week PTN displays
12. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off