Filter
Top Products
242 ICX (International) issued June 2000 ICX-50-700
Chapter 6. DSLT Features Section 700 - Operation
To set Manual Camp-on:
To answer a Camp-on (Call Waiting) signal:
Hardware Requirements
•N/A
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See “Camping a Call Onto a
Busy Extension” on page 240.
Conference Calls
Version 3.0 and higher
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
Any combination of extensions and trunk lines can be in the conference as long as the original
extension is in the conference and the total number of parties does not exceed 8. Only one operation is
used to establish and add to a conference. You simply have to place the current call on hold, dial the
next party and press the CONF key. No different operation or access code is required to add
additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party
conference calls:
•3 extensions
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Dial the extension number. Busy tone
3. Enter the Camp-on (Call Waiting) code (default = 2 [UK/
HK] or 2# [Taiwan, Malaysia, Indonesia]).
• Called party hears alert tone
• Calling party hears ringback tone
4. Remain on the line until the called party answers.
Action Result
1. Replace the handset or press the ON/OFF key.
2. Lift the handset or press the ON/OFF key again to be con-
nected to the waiting call.
OR....
Press the HOLD key.
• Current call placed on hold
• Connected to waiting call