Filter
Top Products
164 ICX (International) issued October 2000 ICX-50-700
Chapter 5. Key Telephone Features Section 700 - Operation
To erase a code stored on an FF key:
Note: You cannot use the following procedure to clear FF keys that have been assigned as trunks.
Trunk keys can only be cleared through system programming.
To check a programmed FF key (Display Phone Only):
Hardware Requirements
•N/A
Considerations
• If a new code is programmed into a key, the previously programmed code is erased.
• FF keys assigned as trunks must be cleared using system programming before new FF
assignments can be made.
• The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
•The ANSWER key functions as listed in the table below.
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Press the PROG key.
3. Press the FF key that was programmed. Programmed code displays
4. Press the HOLD key. Cleared Function displays
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Press the CONF key. C displays
3. Press the FF key to be checked. Programmed data displays
4. Replace the handset or press the ON/OFF key.
Status Condition Operation when ANSWER key is pressed
Idle No incoming ring Ignore.
Incoming ring Monitor ON (speaker) - Auto Answer for incoming ring.
Off-Hook Off-hook signaling Answer for off-hook signaling. Current conversation will be
put on hold automatically.
No off-hook signaling Ignore.
Note: When the extension has 1 non-appearing trunk on hold and 1 non-appearing trunk at talk, ANSWER key
operation is ignored and you can’t put the 2nd non-appearing trunk on hold.