Filter
Top Products
92 ICX (International) issued October 2000 ICX-50-700
Chapter 4. User Maintenance Section 700 - Operation
Operation
To set the Mode Schedule:
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 79.)
81-
User MAINT displays
2. At the 81 level, enter 07.
3. Press the HOLD key. 8107-
System Mode displays
4. Press the HOLD key. 0-
Mode Schedule displays
5. Press the HOLD key. 000 :HHMM
PTN 1-1 Start T displays
6. Enter the start time in hours (two characters) and minutes
(two characters) for the Pattern 1 - first mode.
Note: To clear an entry or existing data, press the
FL/R
key.
7. Press the HOLD key. 001 :
PTN 1-1 Mode displays
8. Enter the desired mode for Pattern 1 - first (0 - None, 1 -
Day 1, 2 - Day 2, 3 - Night, 4 - Night (1), 5 - Night (2)).
Note: To clear an entry or existing data, press the FL/R
key.
9. Press the HOLD key to store the entry. Next pattern mode displays
10. To set additional mode schedules, press the volume up or
down key or press the HOLD key to move to the desired
mode.
Desired pattern mode displays
11. Repeat steps 6-10 until all patterns and modes are set.
(There are 3 total patterns with 5 start time/modes each.)
Note: Entry Positions are listed in Table 12 on page 93.
12. Press the MEMORY key to exit the entry mode. 0-
Mode Schedule displays
13. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off