xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
6
DGS–3426:5#show
Command: show
ext possible completions:
802.1p 802.1x access_profile account
ccounting acct_client address_binding arpentry
attack_log auth_client auth_diagnostics
auth_session_statistics auth_statistics authen
authen_enable authen_login authen_policy authentication
authorization autoconfig bandwidth_control bpdu_tunnel
dhcp dhcp_binding dhcp_relay dhcp_server
dot1v_protocol_group double_vlan error
fdb filter firmware flow_meter
gratuitous_arp greeting_message gvrp hol_prevention
igmp_snooping ipfdb ipif
ipif_vlan_replication_entry iproute ipv6
ipv6route jumbo_frame jwac lacp_port
limited link_aggregation lldp log
log_save_timing loopdetect mac_based_access_control
ac
based
access
control
local mac_based_vlan mac_notification
irror mld_snooping module_info multicast
ulticast
fdb packet port port_security
orts pvid qinq radius
router_ports rspan safeguard_engine scheduling
scheduling_mechanism serial_port session
Sflow sim snmp sntp
ssh ssl stack_device stack_information
stacking_mode stp switch syslog
system_severity time time_range traffic
traffic_segmentation trusted_host utilization
vlan vlan_translation wac
DGS–3426:5#
Figure 2– 6. Next possible completions: Show Command
In the above example, all of the possible next parameters for the show command are displayed. At the next command prompt, the
up arrow was used to re–enter the show command, followed by the account parameter. The CLI then displays the user accounts
configured on the Switch.
