xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
124
DGS-3426:5#show vlan
Command: show vlan
VID : 1 VLAN Name : default
VLAN Type : Static Advertisement : Enabled
Member Ports : 1:1-1:24
Static Ports : 1:1-1:24
Current Tagged Ports :
Current Untagged Ports: 1:1-1:24
Static Tagged Ports :
Static Untagged Ports : 1:1-1:24
Forbidden Ports :
Total Entries: 1
DGS-3426:5#
show gvrp
Purpose Used to display the GVRP status for a port list on the Switch.
Syntax
show gvrp {<portlist>}
Description This command is used to display the GVRP status for a port list on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the GVRP status is to be
displayed. The port list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest switch number, and
the highest port number of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3–2:4 specifies
all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. Non–
contiguous portlist entries are separated by a comma. (ex: 1:1–1:3,1:7–1:9)
Restrictions None.
Example usage:
To display GVRP port status:
