xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
241
config dst
Parameters e_date – Configure the specific date (day of the month) to begin DST.
• <end_date 1–31> – The end date is expressed numerically.
offset [30 | 60 | 90 | 120] – Indicates number of minutes to add or to subtract during the
summertime. The possible offset times are 30,60,90,120. The default value is 60.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch:
DGS–3426:5#config dst repeating s
week 2 s
day tue s
mth 4 s
time 15:00 e
week 2
e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s
week 2 s
day tue s
mth 4 s
time 15:00 e
week 2
e_day wed e_mth 10 e_time 15:30 offset 30
Success.
DGS–3426:5#
show time
Purpose Used to display the current time settings and status.
Syntax
show time
Description This command is used to display system time and date configuration as well as display
current system time.
Parameters None.
Restrictions None.
Example usage:
To display the time currently set on the Switch’s System clock:
DGS–3426:5#show time
Command: show time
Current Time Source : System Clock
Boot Time : 4 May 2006 10:21:22
Current Time : 4 May 2006 15:01:32
Time Zone : GMT +02:30
Daylight Saving Time : Repeating
Offset in Minutes : 30
Repeating From : Apr 2nd Tue 15:00
To : Oct 2nd Wed 15:30
Annual From : 29 Apr 00:00
To : 12 Oct 00:00
DGS–3426:5#
