xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
312
40
COMMAND HISTORY LIST
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
?
config command_history <value 1–40>
show command_history
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax
? {<command>}
Description This command is used to display all of the commands available through the Command
Line Interface (CLI).
Parameters {<command>} – Entering the question mark with an appropriate command will list all the
corresponding parameters for the specified command, along with a brief description of the
commands function and similar commands having the same words in the command.
Restrictions None.
Example usage:
To display all of the commands in the CLI:
DGS–3426:5#?
..
?
clear
clear arptable
clear attack_log
clear counters
clear fdb
clear log
clear port_security_entry port
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x init
config 802.1x reauth
config access_profile profile_id
config account
config address_binding ip_mac ipaddress
config address_binding ip_mac ports
config admin local_enable
config arpentry
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
