xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
259
DGS–3426:5#disable mac_notification
Command: disable mac_notification
Success.
DGS–3426:5#
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1–2147483647> | historysize <int 1–500>} (1)
Description This command is used to monitor MAC addresses learned and entered into the FDB.
Parameters interval <sec 1–2147483647> – The time in seconds between notifications. The user may
choose an interval between 1 and 2,147,483,647 seconds.
historysize <1–500> – The maximum number of entries listed in the history log used for
notification.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch’s MAC address table notification global settings:
DGS–3426:5#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS–3426:5#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist | all] [enable | disable]
Description This command is used to monitor MAC addresses learned and entered into the FDB.
Parameters <portlist> – Specify a port or range of ports to be configured. The port list is specified by
listing the lowest switch number and the beginning port number on that switch, separated
by a colon. Then the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3–2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non–contiguous portlist entries are separated by a
comma. (ex: 1:1–1:3,1:7–1:9)
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC address table
notification on the Switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable port 7 for MAC address table notification:
