xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
194
config 802.1x reauth
Purpose Used to configure the 802.1X re–authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> | all] {mac_address <macaddr>}]
Description This command is used to re–authenticate a previously authenticated device based on
port number.
Parameters port_based – This instructs the Switch to re–authorize 802.1X functions based only on
the port number. Ports approved for re–authorization can then be specified.
mac_based − This instructs the Switch to re–authorize 802.1X functions based only on
the MAC address. MAC addresses approved for re–authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re–authorized. The port list is
specified by listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the highest port
number of the range (also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3–2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> – Enter the MAC address to be re–authorized.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure 802.1X reauthentication for ports 1:1–1:18:
DGS–3426:5#config 802.1x reauth port_based ports 1:1–1:18
Command: config 802.1x reauth port_based ports 1:1–1:18
Success.
DGS–3426:5#
