xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
56
download
• config − Download a new configuration on the switch from a TFTP server.
• <ipaddr> − The IPv4 address of the TFTP server.
• <ipv6addr> − The IPv6 address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the firmware or switch
configuration file on the TFTP server. For example, C:\dgs3427.had.
• config_id <int 1–2> – The Switch can hold two configuration files specified by
section ID. If no configuration ID is specified, the configuration being downloaded
is applied to the system. If a configuration ID is specified, the configuration being
downloaded is saved only to flash memory in the chosen section (1 or 2) and will
not be applied to the system. Keep in mind that configuration ID 1 is the boot-up
configuration unless this is changed using the config command.
• increment − Allows the download of a partial switch configuration file. This allows
a file to be downloaded that will change only the switch parameters explicitly
stated in the configuration file. All other switch parameters will remain
unchanged.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To download a configuration file:
DGS–3426:5#download cfg_fromTFTP 10.48.74.121 unit all c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 unit all c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DGS–3426:5#
DGS–3426:5##––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
DGS–3426:5## DGS–3426 Gigabit Ethernet Switch
DGS–3426:5## Configuration
DGS–3426:5##
DGS–3426:5## Firmware: Build 2.60.B26
DGS–3426:5## Copyright(C) 2009 D–Link Corporation. All rights reserved.
DGS–3426:5##––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
DGS–3426:5#
DGS–3426:5## STACK
DGS–3426:5#
DGS–3426:5#
DGS–3426:5## BASIC
DGS–3426:5#
DGS–3426:5#config serial_port auto_logout never
Command: config serial_port auto_logout never
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message “End of configuration file for DGS–3400” appears followed by the
command prompt.
DGS–3426:5# # ROUTE
DGS–3426:5#
DGS–3426:5# create iproute default 172.18.212.253 1
Command: create iproute default 172.18.212.253 1
Success.
DGS–3426:5#
DGS–3426:5# #––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
DGS–3426:5# # End of configuration file for DGS–3426
DGS–3426:5# #––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
DGS–3426:5# #
