xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
316
DGS–3426:5# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================
DGS–3426 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.60.B26
Copyright(C) 2009 D–Link Corporation. All rights reserved.
================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
show greeting_message
Purpose Used to view the currently configured greeting message configured on the Switch.
Syntax
show greeting_message
Description This command is used to view the currently configured greeting message on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command..
Example usage:
To view the currently configured greeting message:
DGS–3426:5#show greeting_message
Command: show greeting_message
=========================================================================
DGS–3426 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.60.B26
Copyright(C) 2009 D–Link Corporation. All rights reserved.
=========================================================================
DGS–3426:5#
