xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
202
DGS–3426:5#show auth_session_statistics ports 1:16
Command: show auth_session_statistics ports 1:16
Port number : 1:16
SessionOctetsRx 0
SessionOctetsTx 0
SessionFramesRx 0
SessionFramesTx 0
SessionId
SessionAuthenticMethod Remote Authentication Server
SessionTime 0
SessionTerminateCause SupplicantLogoff
SessionUserName Trinity
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_statistics
Purpose Used to display the current authentication statistics.
Syntax
show auth_statistics {ports <portlist> | all]}
Description This command is used to display the current authentication statistics of the Switch on a
per port basis.
Parameters
ports <portlist> − Specifies a range of ports. The port list is specified by listing the lowest
switch number and the beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3–2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order. Non–contiguous portlist entries are separated by a comma. (ex: 1:1–
1:3,1:7–1:9)
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To display the current authentication statistics for port 1:16:
DGS–3426:5#show auth_statistics ports 1:16
Command: show auth_statistics ports 1:16
Port number : 1:16
EapolFramesRx 0
EapolFramesTx 0
EapolStartFramesRx 0
EapolReqIdFramesTx 0
EapolLogoffFramesRx 0
EapolReqFramesTx 0
EapolRespIdFramesRx 0
EapolRespFramesRx 0
InvalidEapolFramesRx 0
EapLengthErrorFramesRx 0
LastEapolFrameVersion 0
LastEapolFrameSource 00–00–00–00–00–00
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
