xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
38
config snmp linkchange_traps
Purpose Used to configure SNMP linkchange traps on the Switch.
Syntax
config snmp linkchange_traps ports [all|<portlist>][enable|disable]
Description This command is used to configure SNMP linkchange traps on the Switch.
Parameters
all − Configure all ports on the Switch.
<portlist> – Specifies a port or range of ports to be configured. The beginning and end of
the port list range are separated by a dash. Non-contiguous portlist entries are separated
by a comma. (ex: 1-3,7-9).
enable | disable – Used to enable or disable SMMP linkchange traps for the switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure SNMP linkchange traps on every port:
DGS–3426:5#config snmp linkchange_traps ports all enable
Command: config snmp linkchange_traps ports all enable
Success.
DGS–3426:5#
