xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
4
?
cable_diag ports
clear
clear address_binding dhcp_snoop binding_entry ports
clear arptable
clear attack_log
clear counters
clear dhcp_binding
clear fdb
clear jwac auth_state
clear log
clear mac_based_access_control auth_state
clear port_security_entry port
clear wac auth_state
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_failover
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x authorization network radius
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
Figure 2– 2. The ? Command
When entering a command without its required parameters, the CLI will prompt you with a Next possible completions: message.
DGS–3426:5#config account
Command: confif account
ext possible completions:
username>
DGS–3426:5#
Figure 2– 3. Example Command Parameter Help
In this case, the command config account was entered with the parameter <username>. The CLI will then prompt to enter the
<username> with the message, Next possible completions:. Every command in the CLI has this feature, and complex commands
have several layers of parameter prompting.
In addition, after typing any given command plus one space, users can see all of the next possible sub–commands, in sequential
order, by repeatedly pressing the Tab key.
To re–enter the previous command at the command prompt, press the up arrow cursor key. The previous command will appear at
the command prompt.
