xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
375
config lldp reinit_delay
Purpose Change the minimum time of the reinitialization delay interval.
Syntax
config lldp reinit_delay <sec 1-10>
Description An re-enabled LLDP port will wait for reinit_delay after last disable command before
reinitializing.
Parameters reinit_delay – The range is from 1 second to 10 seconds. The default setting is 2
seconds.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To changes the re-initialization delay interval to five seconds:
DGS–3426:5#config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DGS–3426:5#
config lldp notification _interval
Purpose Used to configure the timer of the notification interval for sending notification to
configured SNMP trap receiver(s).
Syntax
config lldp notification_interval <sec 5–3600>
Description This command is used to globally change the interval between successive LLDP change
notifications generated by the Switch.
Parameters notification_interval – The range is from 5 seconds to 3600 seconds. The default setting
is 5 seconds.
Restrictions Only Administrator and Operator-level users can issue this command.
Usage Example:
To change the notification interval to 10 seconds:
DGS–3426:5#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS–3426:5#
