xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
285
DGS-3426P:5#config ssh server maxsession 3 contimeout 300 authfail 2 port 1
rekey 10min
Command: config ssh server maxsession 3 contimeout 300 authfail 2 port 1 rekey
10min
Success.
DGS-3426P:5#
show ssh server
Purpose Used to display the SSH server setting.
Syntax
show ssh server
Description This command is used to display the current SSH server setting.
Parameters None.
Restrictions None.
Usage example:
To display the SSH server:
DGS–3426:5# show ssh server
Command: show ssh server
SSH Server Status : Disabled
SSH Max Session : 8
Connection timeout : 120 (sec)
Authenticate failed attempts : 2
Rekey timeout : never
Listened Port Number : 22
DGS–3426:5#
config ssh user
Purpose Used to configure the SSH user.
Syntax
config ssh user <username 15> authmode [hostbased [hostname <domain_name 32> |
hostname_IP <domain_name 32> <ipaddr>] | password | publickey]
Description This command is used to configure the SSH user authentication method.
Parameters <username 15> – Enter a username of no more than 15 characters to identify the SSH user.
authmode – Specifies the authentication mode of the SSH user wishing to log on to the
Switch. The administrator may choose between:
hostbased – This parameter should be chosen to use a remote SSH server for authentication
purposes. Choosing this parameter requires the user to input the following information to
identify the SSH user.
hostname <domain_name 32> – Enter an alphanumeric string of up to 32 characters
identifying the remote SSH user.
hostname_IP <domain_name 32> <ipaddr> – Enter the hostname and the corresponding IP
address of the SSH user.
password – This parameter should be to use an administrator defined password for
authentication. Upon entry of this command, the Switch will prompt the user for a password,
and then to retype the password for confirmation.
publickey – This parameter should be chosen to use the publickey on a SSH server for
authentication.
Restrictions Only Administrator-level users can issue this command.
