xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
310
DGS–3426P:5#show poe ports
Command: show poe ports
Port State Priority Power Limit(mW)
Class Power(mW) Voltage(decivolt) Current (mA)
Status
=================================================================================
1:1 Enabled Critical 12000(User–defined)
0 0 0
0
OFF : Non–standard PD connected
1:2 Enabled Critical 12000(User–
efined)
0 0 0
0
OFF : Interim state during line detection
1:3 Enabled Critical 12000(User–
efined)
0 0 0
0
OFF : Interim state during line detection
1:4 Enabled Low 15400(User–
efined)
0 0 0
0
OFF : Interim state during line detection
1:5 Enabled Low 15400(User–defined)
0 0 0
0
OFF : Interim state during line detection
1:6 Enabled Low 15400(User–defined)
0 0 0
0
OFF : Interim state during line detection
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show poe system
Purpose Used to display the setting and actual values of the whole PoE system.
Syntax
show poe system {units <unitlist>}
Description This command is used to display the system settings for PoE, such as switch power limit,
consumption, remaining useable power and the power disconnection method.
Parameters units <unitlist> – Select the switch in the switch stack for which to show the PoE system
settings. This unit number is based on the unit ID assigned to switches in the switch
stack. The DGS–3426P is currently the only switch in this series with PoE capabilities.
Restrictions None.
Example usage:
To display the power settings for the switch system:
