xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
195
config radius add
Purpose Used to configure the settings the Switch will use to communicate with a RADIUS server.
Syntax
config radius add <server_index 1–3> <server_ip> key <passwd 32> [default |
{auth_port <udp_port_number 1–65535> | acct_port <udp_port_number 1–65535> |
timeout <int 1-255> | retransmit <int 1-20>}(1)]
Description This command is used to configure the settings the Switch will use to communicate with a
RADIUS server.
Parameters
<server_index 1–3> − Assigns a number to the current set of RADIUS server settings. Up
to three groups of RADIUS server settings can be entered on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between the Switch and
the Radius server.
<passwd 32> − The shared–secret key used by the RADIUS server and the Switch. Up to
32 characters can be used.
default − Uses the default UDP port number in both the “auth_port” and “acct_port”
settings.
auth_port <udp_port_number 1–65535> − The UDP port number for authentication
requests. The default is 1812.
acct_port <udp_port_number 1–65535> − The UDP port number for accounting requests.
The default is 1813.
timeout <int 1-255> - The time in second for waiting server reply. The default is 5
seconds.
retransmit <int 1-20> - The count for re-transmit. The default is 2.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DGS–3426:5#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DGS–3426:5#
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1–3>
Description This command is used to delete a previously entered RADIUS server configuration.
Parameters
<server_index 1–3> − Assigns a number to the current set of RADIUS server settings. Up
to three groups of RADIUS server settings can be entered on the Switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
