xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
20
reboot
Purpose Used to restart the Switch.
Syntax
reboot {<string>}
Description This command is used to restart the Switch.
Parameters <string> – This parameter is used to perform the command without prompt if a user
enters /y for yes or /n for no.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To restart the Switch:
DGS–3426:5#reboot
Command: reboot
Are you sure want to proceed with the system reboot? (y|n)
Please wait, the switch is rebooting...
reset
Purpose Used to reset the Switch to the factory default settings.
Syntax
reset {[config | system]} {<string>}
Description This command is used to restore the Switch’s configuration to the default settings
assigned from the factory.
Parameters
config − If the keyword ‘config’ is specified, all of the factory default settings are restored
on the Switch including the IP address, user accounts, the switch history log and banner.
The Switch will not save or reboot.
system − If the keyword ‘system’ is specified all of the factory default settings are
restored on the Switch. The Switch will save and reboot after the settings are changed to
default. Rebooting will clear all entries in the Forwarding Data Base.
If no parameter is specified, the Switch’s current IP address, user accounts, the switch
history log and banner are not changed. All other parameters are restored to the factory
default settings. The Switch will not save or reboot.
<string> - This parameter is used to perform the command without prompt if a user enters
/y for yes or /n for no.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS–3426:5#reset config
Command: reset config
Are you sure to proceed with system reset except Stacking Information, IP
address, log, user account and banner?(y/n)y
Success.
DGS–3426:5#
