xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
125
DGS–3426:5#show gvrp
Command: show gvrp
Global GVRP : Disabled
Port PVID GVRP Ingress Checking Acceptable Frame Type
––––––– –––– –––––––– –––––––––––––––– –––––––––––––––––––––––––––
1:1 1 Disabled Enabled All Frames
1:2 1 Disabled Enabled All Frames
1:3 1 Disabled Enabled All Frames
1:4 1 Disabled Enabled All Frames
1:5 1 Disabled Enabled All Frames
1:6 1 Disabled Enabled All Frames
1:7 1 Disabled Enabled All Frames
1:8 1 Disabled Enabled All Frames
1:9 1 Disabled Enabled All Frames
1:10 1 Disabled Enabled All Frames
1:11 1 Disabled Enabled All Frames
1:12 1 Disabled Enabled All Frames
1:13 1 Disabled Enabled All Frames
1:14 1 Disabled Enabled All Frames
1:15 1 Disabled Enabled All Frames
1:16 1 Disabled Enabled All Frames
1:17 1 Disabled Enabled All Frames
1:18 1 Disabled Enabled All Frames
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
enable double_vlan
Purpose Used to enable the Q-in-Q VLAN feature on the Switch.
Syntax
enable double_vlan
Description This command, along with the disable double_vlan command, enables and disables the
Q-in-Q Tag VLAN. When Q-in-Q VLANs are enabled, the system configurations for
VLANs will return to the default setting, except stacking information, IP address, log, user
accounts and banner setting, in order to enable the Q-in-Q (Double VLAN) VLAN mode.
In the Q-in-Q VLAN mode, normal VLANs and GVRP functions are disabled. The Q-in-Q
VLAN default setting is disabled.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the Q-in-Q VLAN feature on the Switch, thus disabling normal VLANs and GVRP:
DGS–3426:5#enable double_vlan
Command: enable double_vlan
Current Double VLAN mode : Disabled
Enable Double VLAN need to reset system config. Are you sure ?(y/n)y
Success.
DGS–3426:5#
