xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
334
DGS-3426:5#show jwac auth_state ports 1-3
Command: show jwac auth_state ports 1-3
Port MAC Address State VID Priority Aging Time
Idle Time
Block Time
---- ------------------ -------------- ------- ---------- -------------- -------
-
1 00-00-00-00-00-01 Authenticated 4004 3
nfinite
40
1 00-00-00-00-00-02 Authenticated 1234 - Infinite
50
1 00-00-00-00-00-03 Blocked - - 60
-
1 00-00-00-00-00-04 Authenticating - - 10
-
2 00-00-00-00-00-10(P) Authenticated 1234 2 1440
20
3 00-00-00-00-00-20(P) Authenticating - - 20
-
3 00-00-00-00-00-21(P) Blocked - - 200
-
Total Authenticating Hosts :2
Total Authenticated Hosts :3
Total Blocked Hosts :2
DGS-3426:5#
show jwac ports
Purpose Used to display JWAC port configuration.
Syntax
show jwac ports {<portlist>}
This command is used to display JWAC port configuration.
Parameters <portlist> – To specify a port range to show the configuration of JWAC.
Restrictions None.
Example usage:
To display JWAC ports:
DGS-3426:5#show jwac ports
Command: show jwac ports
Port State Aging Time Idle Time Block Time Auth Mode Max
(Minutes) (Minutes) (Seconds) Hosts
----- -------- ---------- --------- ---------- ---------- -----
1 Disabled 1440 Infinite 60 Host_based 50
2 Disabled 1440 Infinite 60 Host_based 50
3 Disabled 1440 Infinite 60 Host_based 50
DGS-3426:5#
