xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
53
DGS–3426:5#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DGS–3426:5#
config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax
config snmp system_location <sw_location>
Description This command is used to enter a description of the location of the Switch. A maximum of
255 characters can be used.
Parameters <sw_location> – A maximum of 255 characters is allowed.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch location for “
HQ 5F
”:
DGS–3426:5#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DGS–3426:5#
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax
config snmp system_name <sw_name>
Description This command is used to configure the name of the Switch.
Parameters <sw_name> – A maximum of 255 characters is allowed.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch name for “
DGS–3400 Switch
”:
DGS–3426:5#config snmp system_name DGS–3400 Switch
Command: config snmp system_name DGS–3400 Switch
Success.
DGS–3426:5#
enable rmon
Purpose Used to enable RMON on the Switch.
Syntax
enable rmon
Description This command is used to enable remote monitoring (RMON) on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
