xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
243
DGS–3$00:4#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DGS–3426:5#
config dhcp_relay add ipif
Purpose Used to add an IP destination address to the switch's DHCP/BOOTP relay table.
Syntax
config dhcp_relay add ipif <ipif_name 12> <ipaddr>
Description This command is used to add an IP address as a destination to forward (relay)
DHCP/BOOTP relay packets to.
Parameters <ipif_name 12> – The name of the IP interface in which DHCP relay is to be enabled.
<ipaddr> – The DHCP server IP address.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To add an IP destination to the DHCP relay table:
DGS–3426:5#config dhcp_relay add ipif System 10.58.44.6
Command: config dhcp_relay add ipif System 10.58.44.6
Success.
DGS–3426:5#
config dhcp_relay delete ipif
Purpose Used to delete an IP destination addresses from the Switch's DHCP/BOOTP relay table.
Syntax
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
Description This command is used to delete an IP destination addresses in the Switch’s
DHCP/BOOTP relay table.
Parameters <ipif_name 12> – The name of the IP interface that contains the IP address below.
<ipaddr> – The DHCP server IP address.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To delete an IP destination from the DHCP relay table:
DGS–3426:5#config dhcp_relay delete ipif System 10.58.44.6
Command: config dhcp_relay delete ipif System 10.58.44.6
Success.
DGS–3426:5#
