xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
104
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DGS–3426:5#config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DGS–3426:5#
config traffic control_recover
Purpose Used to configure traffic control recover for any or all ports.
Syntax
config traffic control_recover [<portlist> | all]
Description Configuring a port for traffic control recover will require an administrator to restart the
specified ports if storm control shuts down the port or ports. That is, if a storm triggers the
action shutdown for a port, it will remain in the shutdown even if the threshold falls below
the value that triggers the storm control action.
Parameters <portlist> – Used to specify a range of ports. This is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3–2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in
numerical order. Non–contiguous portlist entries are separated by a comma. (ex: 1:1–
1:3,1:7–1:9)
all – All ports on switches in the switch stack.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure traffic control recover for ports 1–6 on unit 1:
DGS–3426:5#config traffic control_recover 1:1–1:6
Command: config traffic control_recover 1:1–1:6
Success.
DGS–3426:5#
config traffic trap
Purpose Used to configure traps for traffic control.
Syntax
config traffic trap [none | storm_occurred | storm_cleared | both]
Description This command is used to configure traffic storm trap messages.
Parameters none – Will send no Storm trap warning messages regardless of action taken by the
Traffic Control mechanism.
storm_occurred – Will send Storm Trap warning messages upon the occurrence of a
Traffic Storm only.
storm_cleared – Will send Storm Trap messages when a Traffic Storm has been cleared
by the Switch only.
both – Will send Storm Trap messages when a Traffic Storm has been both detected and
cleared by the Switch.
Restrictions Only Administrator and Operator-level users can issue this command.
