xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
246
DGS–3426:5#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status : Enabled
DHCP/BOOTP Hops Count Limit : 2
DHCP/BOOTP Relay Time Threshold : 23
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Enabled
DHCP Relay Agent Information Option 82 Policy : Replace
Interface Server 1 Server 2 Server 3 Server 4
–––––––––– ––––––––––––– ––––––––––– ––––––––––– ––––––––––––––
System 10.58.44.6
DGS–3426:5#
Example usage:
To show a single IP destination of the DHCP relay configuration:
DGS–3426:5#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
DHCP/BOOTP Relay Status : Enabled
DHCP/BOOTP Hops Count Limit : 2
DHCP/BOOTP Relay Time Threshold : 23
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Enabled
DHCP Relay Agent Information Option 82 Policy : Replace
Interface Server 1 Server 2 Server 3 Server 4
–––––––––– –––––––––––– –––––––––––– –––––––––––– –––––––––––
System 10.58.44.6
DGS–3426:5#
enable dhcp_relay
Purpose Used to enable the DHCP/BOOTP relay function on the Switch.
Syntax
enable dhcp_relay
Description This command is used to enable the DHCP/BOOTP relay function on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable DHCP relay:
DGS–3426:5#enable dhcp_relay
Command: enable dhcp_relay
Success.
DGS–3426:5#
