xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
52
disable snmp traps
Purpose Used to disable SNMP trap support on the Switch.
Syntax
disable snmp traps
Description This command is used to disable SNMP trap support on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To prevent SNMP traps from being sent from the Switch:
DGS–3426:5#disable snmp traps
Command: disable snmp traps
Success.
DGS–3426:5#
disable snmp authenticate traps
Purpose Used to disable SNMP authentication trap support.
Syntax
disable snmp authenticate traps
Description This command is used to disable SNMP authentication support on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable the SNMP authentication trap support:
DGS–3426:5#disable snmp authenticate traps
Command: disable snmp authenticate traps
Success.
DGS–3426:5#
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for the Switch.
Syntax
config snmp system_contact <sw_contact>
Description This command is used to enter the name and/or other information to identify a contact
person who is responsible for the Switch. A maximum of 255 character can be used.
Parameters <sw_contact> – A maximum of 255 characters is allowed.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch contact to “
MIS Department II
”:
