Polycom RealPresence Resource Manager System Operations Guide Add and Monitor Endpoints and Peripherals
100 Polycom, Inc.
Add an Endpoint or Find an Endpoint on the Network
This topic describes how to manually add endpoints and how to find
endpoints on the same network as the system.
This action is not supported for RealPresence Mobile, RealPresence Desktop,
and RealPresence Group systems.
For most endpoints, you enter basic information. The system then locates the
endpoint and retrieves its information.
To add an endpoint to the system or find an endpoint on the network
1 Go to Endpoint > Monitor View and click Add.
2 In the Add New Device dialog box, select the Device Type. For valid
types, see “Supported Endpoint Types” on page 111. For endpoints not
specified in the list, select a Device Type of Other.
3 Enter the IP Address of the endpoint.
4 Click Find Device.
Video Packet
Loss
Specifies the video packet loss for the currently active
call.
Audio Jitter Specifies the audio jitter for the currently active call.
Video Jitter Specifies the video jitter for the currently active call.
Call Info > Video Feed
Near Site The video feed from the endpoint.
Far Site The video feed from the endpoint to which the
endpoint is connected.
System Alerts
Errors Endpoint error message, for example, GK Registration
error.
Warnings Endpoint warning message, for example, Low Battery.
Field Description
When a SIP-only endpoint registers with the Polycom DMA system and does not
register with the RealPresence Resource Manager system’s provisioning service
to become dynamically managed, you must manually add it to the RealPresence
Resource Manager system in order to manage that endpoint.
