Filter
Top Products
2
108 Nokia Network Voyager for IPSO 4.0 Reference Guide
Note
Only point-to-point interfaces can be configured as unnumbered interfaces. Tunnels
cannot be configured as unnumbered interfaces.
3. Click Yes in the Unnumbered Interface field.
4. Click Apply.
Note
If that interface was associated with either a local or remote address or both, they are
automatically deleted.
Note
You do not see local and remote address configuration fields for unnumbered interfaces.
The proxy interface field replaces those fields.
Note
The interface must not be used by a tunnel, and OSPF is the only protocol that the
interface can be running.
5. Select an interface from the Proxy Interface drop-down window.
The Proxy Interface drop-down window shows only those interfaces that have been assigned
addresses.
6. Click Apply.
Note
You must choose a proxy interface for the unnumbered interface to function.
Note
You cannot delete the only IP address of the proxy interface. First, select another proxy
interface and then delete the IP address of the original proxy interface. If the proxy
interface has multiple IP addresses associated with it, you can delete or add addresses.
A proxy interface must have at least one IP address associated with it.
7. Click Save to make your changes permanent.
To change an unnumbered interface to a numbered interface
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the logical interface link to configure in the Logical column. Example:
atm s3p1c1.