Filter
Top Products
12
496 Nokia Network Voyager for IPSO 4.0 Reference Guide
Note
If the message indicates that you have insufficient resources to accommodate a larger
buffer size, take appropriate actions and try this procedure again. For further
information, contact Nokia Technical Assistance Center (TAC).
4. After you verify that the change is appropriate, issue the same command without the
-n
option:
modzap _fw_log_bufsize $FWDIR/boot/modules/fwmod.o 0x200000
A confirmation message is displayed, which you can safely ignore.
5. Reboot the system.
Because these console messages are also written to the FW-1 log message file, Nokia
recommends that you do the following to prevent depleting the disk space allocated for the
FW-1 log message file:
1. Move your log files from the system hard drive to a server.
2. Configure the relocated files by using the Check Point management client GUI (Smart
Dashboard) as follows:
a. Select the Check Point gateway object you are configuring.
b. Under Gateway Object Configuration, select the Logs and Masters section and do the
following:
Specify the amount of free disk space required for local logging.
Specify to stop logging when the free disk space drops below x MB and to start
logging to a new file.
Once a new file is being used, the previously used log files are deleted until the required free
disk space is restored.