Filter
Top Products
9
368 Nokia Network Voyager for IPSO 4.0 Reference Guide
5. (Optional) Enter a new cost in the Metric text box for each interface; then click Apply.
6. (Optional) To configure the interface to not accept updates, click on the on radio button in
the Accept updates field; then click Apply.
7. (Optional) If you want to configure the interface to not send updates, click on in the Send
updates field; then click Apply.
8. (Optional) If you selected RIP 2 for an interface, make sure that Multicast is turned on for
that interface; then click Apply.
Note
When you use RIP 2, always select the multicast option. Nokia recommends that you
not operate RIP 1 and RIP 2 together.
9. (Optional) If you selected RIP 2 for an interface, select the type of authentication scheme to
use from the AuthType drop-down list; then click Apply.
For simple authentication, select Simple from the AuthType drop-down window. Enter the
password in the Password edit box; then click Apply.
The password must be from 1 to 16 characters long.
For MD5 authentication, select MD5 from the AuthType drop-down list. Enter the password
in the MD5 key text box; then click Apply.
10. (Optional) If you selected MD5 as your authentication type and want to ensure
interoperability with Cisco routers running RIP MD5 authentication, click
YES in the Cisco
Interoperability field. The default is no, which means that RIP MD5 is set to conform to
Nokia platforms. Click Apply.
11. To enable RIP on the virtual IP address associated with this interface, click On; then click
Apply.
This option functions only if this router is a VRRP master. You must also configure VRRP to
accept connections to VRRP IPs.
Note
You must use Monitored Circuit mode when configuring virtual IP support. Do not use
VRRPv2 when configuring virtual IP support.
12. To make your changes permanent, click Save.
Configuring RIP Timers
Configuring RIP timers allows you to vary the frequency with which updates are sent as well as
when routes are expired. Use care when you set these parameters, as RIP has no protocol
mechanism to detect misconfiguration.