Nokia IPSO 4.0 Cell Phone User Manual


  Open as PDF
of 510
 
2
62 Nokia Network Voyager for IPSO 4.0 Reference Guide
To configure the IP330 to place an outgoing call
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click isdn-s2p1 in the Physical column of the table.
3. Select PPP from the Encapsulation text box in the Create New Logical Interface table.
Click Apply.
A new logical interface appears in the Interface column of the Logical Interfaces table.
4. Click the logical interface name in the Interface column of the Logical Interfaces table to go
to the Interface page.
5. Enter
206.226.15.2 in the Local Address text box in the Interface Information table.
6. Enter
206.226.15.1 in the Remote Address text box in the Interface Information table.
7. In the Connection Information table, enter Main Office in the Description text box so that
the connection is easily identified.
8. Check Outgoing.
9. Enter
60 in the Idle Time text box in the Connection Information table.
10. Enter
240 in the Minimum Call Time text box in the Connection Information table.
11. Enter the number
384020 in the Remote Number text box in the Connection Information
table.
12. Enter
User in the Name text box under the To Remote Host heading in the Authentication
table.
13. Enter Password in the Password text box under the To Remote Host heading in the
Authentication table.
14. Click Apply.
15. Click Save.
To configure the IP650 to handle an incoming call
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click isdn-s4p1 in the Physical column of the table.
3. Select PPP from the Encapsulation text box in the Create New Logical Interface table.
4. Click Apply.
A new logical interface appears in the Interface column of the Logical Interfaces table.
5. Click the logical interface name in the Interface column of the Logical Interfaces table to go
to the Interface page.
6. Enter
206.226.15.1 in the Local Address text box in the Interface Information table.
7. Enter 2
06.226.15.2 in the Remote Address text box in the Interface Information table.
8. In the Connection Interface table, enter Remote Office in the Description text box so that the
connection is easily identified.
 previous next