Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 417
11. Enter 10.50.10.1 in the Add remote peer IP address text box
12. Click Apply.
To configure Nokia Platform A as an IBGP peer to Nokia Platform C
1. Click Config on the home page.
2. Click the BGP link in the Routing Configuration section.
3. Enter
170.20.1.1 in the Add remote peer IP address text box
4. Click Apply.
To configure EBGP on Nokia Platform A
1. Configure the interface on Nokia Platform A as in “Ethernet Interfaces.”
2. Click BGP under Configuration > Routing Configuration in the tree view.
3. Enter 200 in the Peer autonomous system number text box.
4. Click External in the Peer group type drop-down list; then click Apply.
5. Enter 129.10.21.2 in the Add Remote Peer IP Address text box; then click Apply.
6. Configure route redistribution policy according to “Redistributing Routes to BGP” on page
439.
7. Configure an inbound route filter according to “BGP Route Inbound Policy Example.”
To configure EBGP on Nokia Platform C
1. Click BGP under Configuration > Routing Configuration in the tree view of Platform C.
2. Enter 300 in the AS number text box.
3. Click External in the Peer group type drop-down list; then click Apply.
4. Enter
172.17.10.2 in the Add remote peer IP address text box; then click Apply.
5. Configure route redistribution policy according to “Redistributing Routes to BGP” on page
407.
6. Configure an inbound route filter according to “BGP Route Inbound Policy Example” on
page 446 to allow Nokia Platform C to accept routes from its EBGP peer.
To configure EBGP on Nokia Platform D
1. Configure the interface as in “Ethernet Interfaces.”
2. Click BGP under Configuration > Routing Configuration in the tree view.
3. Enter a router ID in the Router ID text box.
The default router ID is the address of the first interface. An address on a loopback interface
that is not the loopback address (127.0.0.1) is preferred.
4. Enter
200 in the AS Number text box.
5. Enter
100 in the Peer Autonomous System Number text box