Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 299
To configure a modem on COM2, COM3, or COM4
1. Click Network Access and Services under Configuration > Security and Access in the tree
view.
2. Click Modem Configuration next to the appropriate serial port.
The Modem Configuration page appears.
3. Select the On radio button to turn on the modem.
The modem is configured to answer any incoming calls.
4. Enter values for Inactivity Timeout and Status Poll Interval, select whether to enable
dialback and, if yes, enter a value in the Dialback Number field. Table 17 describes these
fields.
5. Click Apply.
6. Click Save to make your changes permanent.
7. If you are configuring a modem on COM4:
a. Select the type of modem (Ositech Five of Clubs, Ositech Five of Clubs II, or Ositech
Five of Clubs III). The Ositech modem page that you selected appears.
b. Enter a country code. Codes are listed in the tables below. You can also view them by
clicking Help from the Network Voyager page.
c. Click Apply.
d. Click Save to make your changes permanent.
Note
When you dial into a Nokia appliance that has an Ositech Five of Clubs III modem installed,
be sure to set the connection rate to 9600 BPS. If you do not, the text you receive from the
appliance will be unreadable.
Table 18 lists the country codes that you select from when entering the code for an Ositech Five
of Clubs card in step 7 of the preceding procedure.
Dialback Number If you enabled modem dialback, enter a value in the Dialback Number
field.
The dialback feature uses this number to back an authenticated user (for
example, 408 555 0093). If dialback is disabled, ignore this value.
Country Code Applies only to COM4. The country setting for the modem sets
parameters in the modem to comply with standards of the specified
country.
Table 17 Modem Configuration Parameters
Parameter Description