Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 81
The Physical Interface page appears.
3. Select the VPI/VCI range in the VPI/VCI Range Configuration list box.
4. Find the ATM logical interface to reconfigure in the Logical Interfaces table and enter a new
set of VPI/VCIs in the VPI/VCI field.
5. Click Apply.
6. Click Save to make your changes permanent.
To change the IP Address of an ATM LIS interface
Note
Do not change the IP address you use in your browser to access Network Voyager. If you
do, you can no longer access the IP security platform with your browser.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the logical interface link for which to change the IP address in the Logical column.
Example:
atm-s2p1c8
The Logical Interface page appears.
3. Enter the IP address for the interface in the IP Address text box.
4. Enter the IP subnet mask length in the Mask Length text box.
5. Click Apply.
6. Click Save to make your changes permanent.
To change the IP MTU of an ATM interface
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. In the Logical column, click the Logical interface link for the item on which to change the IP
MTU. Example:
atm-s2p1c8.
3. Enter a number in the IP MTU text box to configure the devices maximum length (in bytes)
of IP packets transmitted on this interface.
Note
All hosts in the same LIS must use the same IP MTU in their interface to the LIS.
Packets longer than the length you specify are fragmented before transmission.
4. Click Apply.
5. Click Save to make your changes permanent.