Filter
Top Products
2
92 Nokia Network Voyager for IPSO 4.0 Reference Guide
21. Click Yes or No in the Negotiate Magic Number field.
Clicking Yes enables the interface to send a request to negotiate a magic number with a peer.
22. Click Yes or No in the Negotiate Maximum Receive Unit field.
Clicking Yes enables the interface to send a request to negotiate an MRU with a peer.
23. Click Apply.
24. Click Up to return to the Physical Interface page.
25. Click the logical interface name in the Interface column of the Logical Interfaces table to go
to the Interface page.
26. Enter the IP address for the local end of the link in the Local address text box.
27. Enter the IP address of the remote end of the link in the Remote address box.
Click Apply.
28. (Optional) Change the interfaces logical name to a more meaningful name by typing the
preferred name in the Logical name text box.
29. Click Apply.
30. (Optional) Add a comment to further define the logical interfaces function in the Comments
text box.
31. Click Apply.
32. Click Save to make your changes permanent.
To configure a T1 interface for frame relay
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column. Example:
ser-s2p1.
3. (Optional) Click On or Off in the Internal Clock field to set the internal clock on the T1
device.
If you’re connecting to a device or system that does not provide a clock source, set Internal
Clock to On; otherwise, set it to Off. Internal clocking for T1 is fixed at 1.544 Mbps. To
configure slower speeds, you must configure fractional T1 on the Advanced T1 CSU/DSU
Options page.
4. Click Apply.
5. Click Full Duplex or Loopback in the Channel Mode field.
Full duplex is the normal mode of operation.
6. Click the AMI or B8ZS radio button in the T1 Encoding field to select the T1 encoding.
Click Apply.
This setting must match the line encoding of the CSU/DSU at the other end of the point-to-
point link.
7. Click Superframe (D4) or Extended SF radio button in the T1 Framing field to select the T1
Framing format.