Filter
Top Products
2
86 Nokia Network Voyager for IPSO 4.0 Reference Guide
6. Click Full Duplex or Loopback radio in the Channel Mode field.
Full duplex is the normal mode of operation.
7. Click the Frame relay radio button in the Encapsulation field.
8. Click Apply.
9. Enter a number in the Keepalive text box to configure the frame relay keepalive interval.
This value sets the interval, in seconds, between keepalive protocol message transmissions.
These messages are used periodically to test for an active remote system.
Note
This value must be identical to the keepalive value configured on the system at the other
end of a point-to-point link, or the link state fluctuates.
10. Click Apply.
11. Click DTE or DCE in the Interface Type field.
DTE is the usual operating mode when the device is connected to a Frame Relay switch.
12. Click On or Off in the Active Status Monitor field.
This actions sets the monitoring of the connection-active status in the LMI status message.
13. (Optional) Click the Advanced Frame Relay Options link to go to the Frame Relay
Advanced Options page.
The Frame Relay Advanced Options page allows you to configure frame relay protocol and
LMI parameters for this device.
Note
The values you enter depend on the settings of the frame relay switch to which you are
connected or to the subscription provided by your service provider.
14. From the Frame Relay Advanced Options page, click Up to return to the Physical Interface
page.
15. Enter the DLCI number in the Create a new interface DLCI text box.
16. Click Apply.
A new logical interface appears in the Interface column. The DLCI number appears as the
channel number in the logical interface name. The new interface is on by default.
17. (Optional) Enter another DLCI number in the DLCI text box to configure another frame
relay PVC.
18. Click Apply.
Each time you click Apply after you enter a DLCI, a new logical interface appears in the
Interface column. The DLCI entry field remains blank to allow you to add more frame relay
logical interfaces.