Filter
Top Products
9
400 Nokia Network Voyager for IPSO 4.0 Reference Guide
Route Aggregation Example
The figure below shows the network configuration for the example.
In the preceding figure Nokia Platform B, Nokia Platform C, and Nokia Platform D are running
OSPF with the backbone area. Nokia Platform A is running OSPF on one interface and RIP 1 on
the backbone side interface.
Assume that all the interfaces are configured with the addresses and the routing protocol as
shown in the figure. Configure route aggregation of 192.168.24.0/24 from the OSPF side to the
RIP side.
1. Initiate a Network Voyager session to Nokia Platform A.
2. Click Route Aggregation under Configuration > Routing Configuration in the tree view.
3. Enter 192.168.24.0 in the Prefix for New Aggregate text box and enter 24 in the Mask
Length edit box; then click Apply.
4. Click OSPF2 in the New Contributing Protocol drop-down list; then click Apply.
5. Click on in the Contribute all matching routes from OSPF2 field; then click Apply.
6. Click direct in the New Contributing Protocol drop-down list; then click Apply.
7. Click on in the Contribute All Matching Routes from direct field; then click Apply.
8. Click Top.
9. Click the Route Redistribution link in the Routing Configuration section.
10. Click the Aggregates Routes link in the Redistribute to RIP section.
11. Click on radio button in the Export all aggregates into RIP field; then click Apply.
00344
Nokia
Platform B
Nokia
Platform D
Nokia Platform A
Advertise
192.168.24.0
24.49/3024.46/30
26.1/24
Network Prefix: 192.168.0.0
Nokia
Platform C
24.53/3024.50/30
24.45/30
24.54/30
26.2/24
Backbone running RIPv1
Backbone Area
all routers are running OSPF