Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 369
Note
By default, the update interval is set to 30 seconds and the expire interval is set to 180
seconds.
1. Click RIP under Configuration > Routing Configuration in the tree view.
2. To modify the update interval, enter the new update interval in the Update Interval text box;
then click Apply.
3. To modify the expire interval enter the new expire interval in the Expire Interval text box;
then click Apply.
4. To make your changes permanent, click Save.
Configuring Auto-Summarization
Auto-summarization allows you to aggregate and redistribute non-classful routes in RIP 1.
Note
Auto-summarization applies only to RIP 1.
1. Click RIP under Configuration > Routing Configuration in the tree view.
2. To enable auto-summarization, click on in the Auto-Summarization field; then click Apply.
3. To disable auto-summarization click off in the Auto-Summarization field; then click Apply.
4. To make your changes permanent, click Save.
Note
By default, auto-summarization is enabled.
RIP Example
Enabling RIP 1 on an Interface
RIP 1 is an interior gateway protocol that is most commonly used in small, homogeneous
networks.
1. First configure the interface as in “Ethernet Interfaces.”
2. Click RIP under Configuration > Routing Configuration in the tree view.
3. Click on for the eth-s2p1c0 interface; then click Apply.
4. (Optional) Enter a new cost in the Metric edit box for the eth-s2p1c0 interface; then click
Apply.