Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 243
To enable sequence validation in the Check Point management application and IPSO, follow
these steps:
a. On the main Configuration page in Nokia Network Voyager, click Advanced System
Tuning (in the System Configuration section).
b. On the Advanced System Tuning page, click the button to enable sequence validation.
c. Enable sequence validation in the Check Point management application.
d. Push the new policy to the IPSO appliance.
Clustering Example (Three Nodes)
This section presents an example that shows how easy it is to configure an IPSO cluster. The
following diagram illustrates the example configuration.
This example cluster has three firewall nodes: A, B, and C. To the devices on either side of the
cluster, A, B, and C appear as a single firewall.
The following sections explain the steps you would perform to configure this cluster.
192.168.1.0
192.168.2.0
Secondary Cluster Protocol
Network: 192.168.4.0
Cluster IP: 192.168.4.10
Cluster
(ID 10)
External
Router
Primary Cluster Protocol
Network:192.168.3.0
Cluster IP: 192.168.3.10
.1 .1
.1 .1
Firewall B
eth-s1p1
eth-s2p1
eth-s3p1
eth-s4p1
.2
.2 .2
.2
.3 .3
.3 .3
Firewall A
eth-s1p1 eth-s3p1
eth-s4p1eth-s2p1
Internal
Cluster IP
External
Cluster IP
192.168.2.5
Internal
Router
192.168.1.5
192.168.2.10 192.168.2.10
192.168.2.10
192.168.1.10 192.168.1.10192.168.1.10
Firewall C
eth-s1p1
eth-s2p1
eth-s3p1
eth-s4p1
VPN-1/FireWall-1
Synchronization Network