Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 431
4. Enter 129.10.2.2 in the Additional Gateway edit box; then click Apply.
5. Enter
129.10.1.2 in the Additional Gateway edit box; then click Apply.
Configuring a Static Route on Platform B
1. Click Static Routes under Configuration > Routing in the tree view.
2. Enter
1.2.3.4 in the New static route text box to reach the loopback address of Platform
A.
3. Enter
32 in the Mask length text box; then click Apply.
4. Enter
129.10.2.1 in the Additional Gateway edit box; then click Apply.
5. Enter
129.10.1.1 in the Additional Gateway text box; then click Apply.
Configuring an EBGP Peer on Platform A
1. Configure an EBGP peer on Platform A as in “Ethernet Interfaces.”
2. Enter
1.2.3.4 as the local address on the main BGP configuration page. Click Apply.
3. Configure the inbound and route redistribution policies.
4. Click the link for specific peer you configured in Step 1.
This action takes you the page that lets you configure options for that peer.
5. In the Nexthop field, click on next to EBGP Multihop to enable the multihop option; then
click Apply.
6. (Optional) Enter a value in the TTL text box to set the number of hops over which the EBGP
multihop session is established.
The default value is 64 and the range is 1 to 255. Click Apply.
Configuring an EBGP Peer on Platform B
1. Configure an EBGP peer on Platform B as in “Ethernet Interfaces.”
2. Enter
5.6.7.8 as the local address on the main BGP configuration page.
3. Configure the inbound and route redistribution policies.
4. Click the link for specific peer you configured in Step 1. This action takes you the page that
lets you configure options for that peer.
5. In the Nexthop field, click on next to EBGP Multihop to enable the multihop option; then
click Apply.
6. (Optional) Enter a value in the TTL text box to set the number of hops over which the EBGP
multihop session is established.
The default value is 64 and the range is 1 to 255. Click Apply.