Nokia IPSO 4.0 Cell Phone User Manual


  Open as PDF
of 510
 
2
44 Nokia Network Voyager for IPSO 4.0 Reference Guide
5. In the Ethernet Interface drop-down box, select the Ethernet interface you wish to associate
with the PPPoE logical interface in the.
6. In the Mode drop-down box, select a connection mode.
7. In the Timeout text-box, enter a time in seconds.
8. (Optional) In the Peername text-box, enter the name of the PPPoE server.
Note
If you use the Peername field, only the PPPoE server named in the field will be allowed
to connect to the system.
9. In the MTU text-box, enter the maximum byte size to be transmitted. The default is 1492
bytes.
10. Enter a value in the MSS Clamping text box if end devices connected to this interface are
experiencing connectivity problems with specific destinations. See “Configuring MSS
Clamping” for more information.
11. In the Authentication Type drop-down box, select an authentication type. If you selected
PAP or CHAP, you must enter a user name in the Username text box and a password in the
Password text box.
12. Click Apply
13. Click Save to make your changes permanent.
To create more configuration profiles, repeat these steps.
14. Display the Interface Configuration page.
15. Click the link for the physical PPPoE interface.
16. Chose a configuration profile you created in the preceding steps from the Create a new
interface with PPPoE profile drop-down box.
17. Click Apply.
18. Click the lin for the logical interface you wish to configure.
This takes you to the Logical interface page.
19. In the Interface type drop-down box, select an interface type.
If you select Static Interface, you must provide the IP address of the logical interface in
the Local Address text box and the IP address of remote point-to-point interface in the
Remote Address text box.
If you select Unnumbered, the proxy interface should be a logical interface of the
physical interface that is associated the PPPoE profile.
If you select Dynamic, the Local Address should be the IP address of the logical
interface. The Remote Address should be the name of the logical interface.
 previous next