Filter
Top Products
9
422 Nokia Network Voyager for IPSO 4.0 Reference Guide
To configure an IBGP peer for Nokia Platform B
1. Enter
100 in the Peer Autonomous System Number text box.
2. Click Internal in the Peer Group type drop-down list; then click Apply.
3. Enter
20.10.10.2 in the Add Remote Peer IP Address text box; then click Apply.
To set the local preference value for an IBGP peer
1. Click Up to take you back to the main Config page for Network Voyager.
Click the Inbound Route Filters link in the Routing Configuration section.
2. Click Based on Autonomous System Number.
3. Enter
512 (or any unique number in the range of 512 to 1024) in the Import ID text box.
4. Enter
100 in the AS text box.
5. Enter
200 in the LocalPref text box.
6. Click Apply.
7. Click Accept in the All Routes from BGP AS 100 field; then click Apply.
To configure the static routes required for an IBGP session
1. Click Static Routes under Configuration > Routing Configuration in the tree view.
2. Enter
10.10.10.0 in the New static route text box.
3. Enter
24 in the Mask length text box.
4. Enter
20.10.10.2 in the Gateway text box; then click Apply.
To configure the static routes required for Nokia Platform B
1. Configure the interface as in “Ethernet Interfaces.”
1. Click BGP under Configuration > Routing Configuration in the tree view.
2. Enter
20.10.10.2 in the Router ID text box.
3. Enter
100 in the AS number text box.
4. Enter
20.10.10.1 in the Add remote peer ip address text box, then click Apply.
5. Click Top button at the top of the configuration page.
6. Click the Static Routes link in the Routing Configuration section.
7. Enter
10.10.10.0 in the New Static Route text box.
8. Enter
24 in the Mask Length text box.
9. Enter
20.10.10.1 in the Gateway text box; then click Apply.